IPV6 WWAN
As the page loads the applied configuration is displayed by default, by using dropdown menu and text box you can change IPV6 Configuration
IPV6 Support:
This dropdown enables/ disables IPv6 functionality. The IPv6 call is established using the stored network policy if auto connect is enabled.
Backhaul:
WWAN backhaul bring up using the network policy in the xml file.
Connect to backhaul request will trigger connect to the WWAN Network .
The current backhaul state is displayed in the textbox.
WWAN Policy:
You can view and update the WWAN Policy information
Tech preference:
A single connection is attempted using the following specified technology preferences
3GPP profile id:
Shows CDMA profile ID for IPv6. You can edit it using text box.
3GPP2 profile id:
Shows UMTS profile ID for IPv6. You can edit it using text box.
To save and cancel changes
Click UPDATE to save the new setting.
Click REFRESH to discard any unsaved changes.
IPV6 WWAN Statistics
You can display and reset WWAN statistics along with WWAN IP configuration for the mobile AP as
Bytes received on WWAN.
Bytes transmitted on WWAN.
Packets received on WWAN.
Packets transmitted on WWAN.
Packets dropped on Rx WWAN.
Packets dropped on Tx WWAN.
IPv6 public IP
IPv6 primary DNS address
IPv6 Secondary DNS Address
STATION mode connection status
In AP-STA mode, our MTP works as an AP and as a station to connect to the external hotspot at the same time.
When external hotspot is available, backhaul connection is switched to WLAN backhaul and when external hotspot is not available backhaul connection is switched back to WWAN dynamically.
BACK button:
CLICK on it to Go back to WWAN PAGE